Concrete Sidewalk & Walkway Replacement in Wichita, KS
Wichita Concrete Pros replaces sidewalks and walkways for homes across Wichita and Sedgwick County, Kansas. We are a licensed and insured concrete contractor. This service covers approach walks, front-entry paths, and the cracked or lifted trip-hazard slabs that show up along an older concrete run.
A new walk is 4000 PSI air-entrained concrete, four inches thick over a compacted crushed-stone base, with control joints cut across it and isolation joints where it meets anything rigid. The air-entrained mix resists the surface flaking that salt and freeze-thaw cause. A walk poured flat on clay with no base and no separation joints is the one that lifts a corner and catches a toe.
Trip-Hazard Slabs
A lifted panel is where a walkway turns dangerous. When one section rides higher than the next, the ground beneath it has moved. We remove those panels and repour them flush with the run, on a rebuilt base so the fix holds. Cutting the high edge down only hides the lift for a season.
Code Slope and Drainage
A walk is pitched across its width so water runs off instead of standing on it. An approach walk near the street also has to hold the grade the city allows, so it stays level enough to use safely. We form both slopes into the pour, because water that ponds and freezes on a walk is what breaks the surface first.
Frost, Clay, and Isolation Joints
Expansive clay and winter frost push the ground under a thin walk up and down. Where the walk meets the porch steps and the driveway, an isolation joint lets each piece move without cracking its neighbor. We separate the walk from those rigid points and pour it on a moisture-stable stone base to cut the movement down.
What It Costs
Sidewalk work in Wichita depends on how many linear feet come out and whether it is a few panels or a full run. Replacing a couple of trip-hazard slabs is a small job. A whole front walk with the old concrete hauled off costs more. Every walk gets a free written estimate first.
Got a raised slab someone keeps tripping on? (316) 555-0148 gets you a free look. We replace walks the same way in Andover and across Sedgwick County.
One sidewalk slab is higher than the next. Can you fix that?
A raised slab is a trip hazard, and on clay it usually means the section under it lifted. We take out the offending panels and repour them level with the run, on a rebuilt base so they stay put. Grinding the lip down only shaves the symptom and leaves the base problem underneath.
Do sidewalks need a slope?
Yes. A walkway is pitched slightly across its width so water sheets off instead of ponding and freezing on the surface. A public approach walk also has to meet the slope limits the city sets for a safe, walkable grade. We set both when we form the walk.
Why do my walkway slabs keep separating and tilting?
Frost and expansive clay move the ground under a thin walk. Without isolation joints where the walk meets the steps and the driveway, the sections push against each other and crack. We separate the walk from anything rigid it touches and pour it on a stable stone base so each panel moves less.
How thick is a concrete sidewalk poured?
A residential walkway is poured four inches thick over a compacted crushed-stone base, with control joints tooled or cut across it. Where a driveway crosses the walk and cars roll over it, we thicken that section so the load does not crack it. The base prep is the same either way.